LTS the Hub For Nuts, Bolts And Washers…
By davidsmith
LTSsupply carries the largest range of stainless steel fasteners including hex bolts, wing nuts, flat washer, machine and socket screw, cap screws, dowel pins and much more. We offer fast delivery through having the largest stock of stainless fasteners.
Sometimes you get stuck on a project or repair job, and you need to know how to un-stick tight, crusted nuts, bolts, and washers. We have all the products you need at
First tip: you can use a torch to heat a fastener or self-tapping screw, which often loosens the lock or blockage that was causing the screw to be unmovable. Heat, oil and tapping in combination will help undo most all sticky fastener situation. Be careful not to heat the bolt too much, or it will become too soft. Just about a minute or so for the average-size bolt will be suitable. Then, wait a few moments for the bolt to be cool enough to touch, spray a bit of oil on and around it, as well as on the machine screw nut, for example, if that is possible. Tap the screw a few times to loosen up the threads inside, and then try your hand again at removing it.
Another trick: When a bolt head has worn down and become rounded, wrenches end up slipping off them and can’t gain friction. If this happens, try using a pair of locking pliers. Grip the pliers tightly, because you may only have a few more chances before the head is even more rounded and can’t produce friction with the pliers. If this doesn’t work, try the same heat, oil, and tapping technique as described above.
If you need more help getting your machine screw and socket screws loosened, don’t hesitate to contact us at LTS Supply and ask for advice. We are more than willing to help.